Arctic Cat 2014 M 2-STROKE Service Manual page 49

 NOTE: For assembling purposes, note the indenta-
tion (A) of the stator plate is aligned with the harness
opening (B) in the crankcase.
 NOTE: The stator plate screws have Loctite applied
to the threads during assembly. Using an impact
driver, apply a sharp blow to the head of each screw
to break the Loctite loose before removal.
8. Remove the cap screws securing the APV assemblies
to the cylinders; then remove the APV assemblies
and set them aside. Account for all four dowel pins
and make sure the pins do not fall into the engine.
9. Disconnect the coolant hose from the back of the cyl-
inder head.
10. Remove the cap screws with O-rings securing the
cylinder head (in the order shown); then separate the
head from the cylinders. Account for the O-rings on
top of the cylinders.
46
CWI-005A
11. Remove the four nuts securing the fuel rail to the
back of the cylinders; then remove the fuel rail and
injectors as an assembly. Account for all gaskets.
CWI-005B
12. Remove the eight nuts securing the cylinders to the
crankcase; then using a soft hammer, gently tap the
cylinders and remove from the crankcase by lifting
them straight up off their studs. Account for a gasket
and alignment pins.
When removing a cylinder, be sure to support the piston
to prevent damage to the crankcase and piston.
CWI-006A
CAUTION
CWI-009
CWI-010
CWI-011A