Arctic Cat 2014 M 2-STROKE Service Manual page 171

8. Using Spanner Wrench, tighten the bearing cap.
 NOTE: When tightening the bearing cap, note air
and excess oil being bled from the hole in the cap.
9. Install the bleed ball and set screw into the bearing
cap.
10. Charge the shock with nitrogen to 200 psi.
168
11. Using a 3/16-in. Allen-wrench, tighten the
PC246
nitrogen bladder.
12. Install the air valve ball by gently tapping it with a
rubber hammer.
PC245
13. Test the shock for proper operation.
PC244 14. Using compressed air, blow all oil from the holes in
the bearing cap.
Always wear an approved pair of safety glasses when
using compressed air.
15. Lubricate the seal on the air chamber with Fox Float
Fluid.
! WARNING
FS164
FS165
FS166