Arctic Cat 2014 M 2-STROKE Service Manual page 170

2. Carefully install the floating piston into the shock
body until it is below the threads.
3. Using Floating Piston Location Gauge, install the
floating piston while using the inflation needle to
vent the shock body.
 NOTE: Refer to the Suspension Specifications -
Shock Absorbers sub-section in the General Informa-
tion section.
4. Using Fox Racing Shock Oil, fill the shock body to
the bottom of the threads; then, allow to sit 1-2 min-
utes to ensure no air is in the oil.
FS154
5. Lubricate the O-ring on the underside of the end cap
with shock oil.
FS155
6. Lower the shock rod into the shock body until the
piston is submerged in oil.
7. While keeping the shock rod fully extended, thread
the bearing cap into position.
FS156
FS157
FS158
FS159
FS160
167