Basic Wiring Diagram - Sanyo 26 series Installation Instructions Manual

6-3. Basic Wiring Diagram

CAUTION
Use shielded wires for inter-unit control wiring and
ground the shield on both sides. (Fig. 6-5)
Otherwise misoperation because of noise may occur.
I Wiring procedure
Install the wiring according to the above wiring diagram.
G
Address setting is automatically executed after turn-
ing on the system.
An indoor unit address is assigned to each indoor
unit.
RC
G
Operation takes place successively at intervals of 1
(WD)
second, by using combinations of the address setting
of each unit.
Carry out wiring correctly
(incorrect wiring will damage
the equipment).
Ground
I Diagram of outer dimensions
5/32
62
Shielded wire
Ground
Fig. 6-5
4-23/32 5/8