Wheels And Tires; Maintenance Procedures (Cont'd) - Can-Am DS70 Operator's Manual

MAINTENANCE PROCEDURES
vmo2008-008-048_a
1. Drive chain roller
Sprocket and Pinion Inspection
Check the sprocket axle and pinion for
distortion. Replace if necessary.
1. Good
2. Replace
CAUTION Replace
sprocket axle and pinion together
to prevent rapid chain and sprock-
et wear. Install a new retaining ring
each time the pinion is removed.
______________________
94

Wheels and Tires

Tire Pressure
Tire pressure greatly affects ve-
hicle handling and stability. Low
pressure may cause tire to deflate
and rotate on wheel. Overpres-
sure may burst the tire. Always
follow recommended pressure.
Since tires are low-pressure types,
a manual pump should be used.
Check pressure when tires are cold
before using the vehicle. Tire pres-
sure changes with temperature and
altitude. Recheck pressure if one of
these conditions has changed.
For your convenience, a pressure
gauge is supplied in tool box.
MINIMUM
MAXIMUM
Although the tires are specifically de-
signed for off-road use, a flat may still
occur. Therefore, it is recommended
to carry a tire pump and a repair kit.
chain,
Tire/Wheel Condition
Occasionally, wheel bolts should be
removed to apply anti-seize lubricant
to ease future removal. This is particu-
larly important when vehicle is used in
salt-water environment or in mud. Re-
move one nut at a time, lubricate then
retorque.
Check tires and rims for damage and
wear.
Replace if necessary.
WARNING
TIRE PRESSURE
FRONT AND REAR
25 kPa (3.5 PSI)
35 kPa (5 PSI)