Table 3-9 Alom Cmt Parameters Used For Post Configuration - Sun Microsystems Sun Fire T2000 Service Manual

lists the ALOM CMT variables used to configure POST and
TABLE 3-9
shows how the variables work together.
Note – Use the ALOM CMT setsc command to set all the parameters in
except setkeyswitch.
ALOM CMT Parameters Used For POST Configuration
TABLE 3-9
Parameter Values
setkeyswitch normal
diag
stby
locked
diag_mode off
normal
service
diag_level min
max
diag_trigger none
user_reset
power_on_reset
error_reset
all_resets
diag_verbosity none
Description
The system can power on and run POST (based
on the other parameter settings). For details see
. This parameter overrides all other
FIGURE 3-10
commands.
The system runs POST based on predetermined
settings.
The system cannot power on.
The system can power on and run POST, but no
flash updates can be made.
POST does not run.
Runs POST according to diag_level value.
Runs POST with preset values for diag_level
and diag_verbosity.
If diag_mode = normal, runs minimum set of
tests.
If diag_mode = normal, runs all the minimum
tests plus extensive CPU and memory tests.
Does not run POST on reset.
Runs POST upon user initiated resets.
Only runs POST for the first power on. This
option is the default.
Runs POST if fatal errors are detected.
Runs POST after any reset.
No POST output is displayed.
Chapter 3 Server Diagnostics
FIGURE 3-10
TABLE 3-9
3-27