Sun Microsystems Sun Fire T2000 Service Manual page 154

2. Rotate the PCI hold-down bracket (located on the edge of the chassis) 90 degrees
so that the chassis edge can accept the card.
You might need to loosen the screw that holds the bracket to the chassis.
3. Line up the PCI card with the PCI connector on the rear of the motherboard.
4. Push the card into the connector so it is fully seated.
5. Rotate the PCI hold-down bracket to the closed position and secure the screw on
the bracket.
6. Install any cables that go to the PCI card.
7. Perform the procedures described in
Replacement" on page
6-8 Sun Fire T2000 Server Service Manual • July 2007
Section 5.1, "Common Procedures for Parts
5-1.