Lan Input/Output - Furuno FA-100 Installation Manual

3.5 LAN Input/Output

The FA-100 supports Ethernet based on LAN. Its protocol is 10BASE-T and the
transmission rate is 10 Mbps. To connect the FA-100 with other equipment (such as
a PC), use a LAN cable category 4 or higher with shield (SDT). Connect it to the
PC with an RJ-45 connector, and connect to the FA-100 with a D-sub 9 pin
connector, to avoid noise leakage. To use a commercial LAN cable, remove one
connector and solder a D-sub 9 pin connector, supplied in the installation materials.
FA-100
LAN (10B-T)
TD+
TD-
RD+
RD-
GND
F.GND
18
Twisted pair cable
>1>
>2>
>3>
>4>
>8>
>9>
RJ-45 (Category 4 and more, SDT)
3 RD+
6 RD-
1 TD+
2 TD-