Attaching Lan Kit (Option) - Furuno FA-150 Installation Manual

4.

ATTACHING LAN KIT (OPTION)

To connect to PC network or NAVNET 3D network, the optional LAN kit is required.
1
2
How to attach the LAN kit
1. Dismount the bottom cover.
2. Attach NET100 board 03P9332 to the 24P0035 board, referring to the figure
shown below.
J9
Unfasten 4 screw
3. Set DIP switch SW3 #4 as follows.
• For NAVNET 3D network: SW3 #4 OFF (default)
• For PC network: SW3 #4 ON
How to set LAN port for PC network
1. Press the MENU key, choose [INITIAL SETTING], enter password, choose [SET
I/O PORT] and press the ENT key to show the [SET I/O PORT] sub menu.
2. Press  or  to choose [SET LAN PORT] and
press the ENT key. The window shown in the
right appears.
3. Press the ENT key to show the mode selecting
window.
4. Press  or  to choose suitable mode and
press the ENT key.
[STANDARD]: When connecting a LAN device
[MONITOR]: When connecting a monitor
[SERVICE]: Data output for service man
[DISABLE]: No connection
LAN kit (Type: OP24-8, Code: 005-956-020)
Name
NET100 board
Hex. spacer
24P0035
SW3
Transponder (Bottom cover removed)
Code no.
001-099-710
000-159-292-10
03P9332 03P9332
J9
24P0035
Attaching 03P9332
Qty Remark
1 03P9332
4
Use screws removed in left figure.
NET Board03
Spacer
[SET LAN PORT]
MODE : STANDARD
IP ADDRESS
172. 031. 024. 001
SUB NET MASK
255. 255. 000. 000
PORT NO. : 10000
QUIT [MENU]
4-1