Table of Contents
Advertisement
1 GETTING STARTED
1 GETTING STARTED
To help ensure years of trouble free operation, please read through the following chapter for information to help guide you
through the initial installation procedures of your new relay.
CAUTION: THE OPERATOR OF THIS INSTRUMENT IS ADVISED THAT IF THE EQUIPMENT IS USED IN A MANNER
NOT SPECIFIED IN THIS MANUAL, THE PROTECTION PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED
INSTALLATION MUST BE ACCORDING TO THE NATIONAL ELECTRIC CODE OF THE APPROPRIATE COUNTRY
IMPORTANT WARNING: For upgrading the relay firmware to version 4.00 or later, it is mandatory that the
EnerVista MII Setup version is 1.10 or higher. For firmware version 5.00 or later, the EnerVista MII Setup
version must be 2.10 or later. Otherwise it may result in damage to the relay
It will take a few seconds for the relay to restart after the completion of the update process. Therefore, before
unplugging the relay, please make sure that the relay main screen shows the analog inputs values.
GEK-106237P
MIFII Digital Feeder Relay
1
1-1
Advertisement
Table of Contents
