Select Message Length - Newland NLS-HR200 User Manual

Symbologies
Data Matrix

Select Message Length

It is used to program the valid reading length (bytes) of Data Matrix. The engine will produce an
error beep, if the data length captured does not match the valid reading length.
Data Matrix Message Length is defined by "Min. Message Length" and "Max. Message
Length".
Min Message Length（default: 1）
【Pro CMD：0504030】
2D bar code Message Length should not exceed 65535 bytes.
Max Message Length should not be shorter than Min Message Length.
To read a fixed length Data Matrix, Please program Max & Min Message Length to the same
value.
Program Data Matrix, Min Message Length 8 bytes, Max Message Length 12 bytes.
1.
2.
3.
4.
5.
6.
7.
8.
9.
nlscan.com
"Code Programming ON"
"Select Min Message Length"
Digit code "8", see Digit Code
"Save Programming", see Digit Code
"Select Max Message Length"
Digit code "1"
Digit code "2"
"Save Programming"
"Code Programming OFF"
Max Message Length（default:3116 ）
【Pro CMD：0504040】
Tools
Code Programming ON
Code Programming OFF
Page 88