Gestetner B003 Service Manual page 682

Scanner Switch 0C
No FUNCTION
0 Action when an original jam
has occurred while scanning
the original into memory for
memory tx
0: Continues scanning after
recovery
1: Stops scanning and erases
all scanned pages for that job
1 Setting when an original size
to cannot be recognized
2 Bit 2 1 Setting
0 0 No original
A5 )
0 1
A5 *
1 0
1 1 No original
3-5 Not used
6 Scan width used for a
document set in the ADF when
the width is less than 230 mm.
0: A4 (210 mm)
1: LT (216 mm)
7 Not used
Scanner Switch 0D
No FUNCTION
0-6 Not used
7 Scan width for A5 lengthwise or
B5 lengthwise originals
0: 210 mm (8.5")
1: Original width
SM
COMMENTS
This bit is only effective when parallel memory tx is
disabled (user parameter 07 - bit 2).
If parallel memory tx is enabled, the machine always
erases the scanned pages when an original jam
occurs. The machine then asks the user to retry
from the first page, even if the parallel memory tx is
not actually used.
0: The machine displays a message asking the user
to put the jammed page back into the original stack,
and continues scanning.
The message is displayed for the time period
specified by scanner switch 0E, bit 2.
1: The machine erases all the scanned pages and
asks the user to retry from the first page.
Do not change the setting.
This bit is set at "1" when the country code is set to
the US.
Do not change the setting.
COMMENTS
Do not change the settings.
0: The machine scans the original as 210 mm (8.5")
width. The transmitted image has a blank area on
the right.
1: The machine scans 148 mm (A5) or 182 mm (B5)
and centers the scanned data on a 216 mm width
transmitted image.
3-25
BIT SWITCHES
SP No. 1-102-013
SP No. 1-102-014
B003/B004/B006/B007