Gestetner B003 Service Manual page 676

System Switch 1D
No FUNCTION
0 RTI/CSI/CPS display
0: Disabled
1: Enabled
1-7 Not used
System Switch 1E
No FUNCTION
0 Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
1 Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
2 RTI/CSI display priority
0: RTI 1: CSI
3 File No. printing
0: Enabled
1: Disabled
4 Action when authorized
reception is enabled but
authorized RTIs/CSIs are not
yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
SM
COMMENTS
1: RTI/CSI/CPS is displayed on the top line of the
LCD panel during communication.
Do not change the settings.
COMMENTS
This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the
report (e.g., no paper).
0: If the buffer memory of the communication
records for the Journal has become full, fax
communications will become impossible, to prevent
overwriting the communication records before the
machine prints them out.
1: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite the
oldest communication records.
Cross Reference
+ Automatic Journal output - User switch 03 bit 7
Number of communication records for the
+
Journal:
200 records (standard)
1000 records (with the Function Upgrade unit
installed)
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
1: File numbers are not printed on any reports.
If authorized reception is enabled but the user has
stored no acceptable sender RTIs or CSIs, the
machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from
any sender that includes an RTI or CSI, and to block
messages from senders that do not include an RTI
or CSI, change this bit to "1", then enable
Authorized Reception.
Otherwise, keep this bit at "0 (default setting)".
3-19
BIT SWITCHES
SP No. 1-101-030
SP No. 1-101-031
B003/B004/B006/B007