Gestetner B003 Service Manual page 662

SP2-XXX (RAM Data)
2
Mode No.
101 RAM Read/Write
001
102 Memory Dump
001 G3-1 Memory Dump
002 G3-2 Memory Dump
003 G3-3 Memory Dump
004 G4 Memory Dump
103 G3-1 NCU Parameters
001 – 023 CC, 01 – 22
104 G3-2 NCU Parameters
001 – 023 CC, 01 – 22
105 G3-3 NCU Parameters
001 – 023 CC, 01 – 22
SP3-XXX (Tel Line Settings)
3
Mode No.
101 Service Station
001 Fax Number
002 Select Line
102 Serial Number
000
103 PSTN-1 Port Settings
001 Select Line
002 PSTN Access Number Enter the PSTN access number for the
003 Memory Lock
Disabled
004 Transmission
Disabled
104 PSTN-2 Port Settings
001 Select Line
002 PSTN Access Number Enter the PSTN access number for the G3-
SM
SERVICE PROGRAM MODE
Function
Change RAM data for the fax board directly.
☛ Section 3.5 Service RAM Addresses
Print out RAM data for the fax board. ☛
Section 3.5 Service RAM Addresses
Print out RAM data for the SG3-1 board.
Print out RAM data for the SG3-2 board.
Print out RAM data for the SiG4 board.
NCU parameter settings for the standard
G3 board. ☛ Section 3.3 NCU Parameters
NCU parameter settings for the optional G3
board. ☛ Section 3.3 NCU Parameters
NCU parameter settings for the optional G3
board. ☛ Section 3.3 NCU Parameters
Function
Enter the fax number of the service station.
Select the line type.
Enter the fax unit's serial number.
Select the line type setting for the G3-1 line.
If the machine is installed on a PABX line,
select "PABX", "PABX(GND)" or
"PABX(FLASH)".
G3-1 line.
If the customer does not want to receive
transmissions using Memory Lock on this
line, turn this SP on.
If you turn this SP on, the machine does not
send any fax messages on the G3-1 line.
Select the line setting for the G3-2 line. If
the machine is installed on a PABX line,
select "PABX", "PABX(GND)" or
"PABX(FLASH)".
2 line.
3-5 B003/B004/B006/B007