Gestetner B003 Service Manual page 670

Rev. 09/2002
System Switch 02
No FUNCTION
6 Memory read/write by RDS
7 Bit 7 6
0 0
0 1
1 0
1 1
System Switch 03
No FUNCTION
0 Length of time that RDS is
to temporarily switched on when
7 bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No FUNCTION
0-2 Not used
3
Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
⇒
4 Not used
5 Memory file transfer operation
0: Enabled
1: Disabled
SM
(0,0): All RDS systems are always locked out.
Setting (0,1), (1,0): Normally, RDS systems are locked out,
Always disabled but the user can temporarily switch RDS on to allow
User selectable RDS operations to take place. RDS will
User selectable automatically be locked out again after a certain
Always enabled time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
Do not change the settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10 bytes
each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for service
technicians).
Do not change the settings.
If the machine is unable to print fax messages due
to a mechanical problem, set this bit to 0 to transfer
all messages in memory (including confidential rx
messages) to another terminal for printout.
Transfer procedure for key operators
1. Press 'User Tools/Counter', then 'Facsimile
Settings', and finally 'Key Operator Tools'.
2. Select 'Memory File Transfer' and specify a
destination for the machine to transfer all the files.
3. Press 'Start'.
Normally this should be reset to 1 after transfer,
otherwise anyone who knows how to enter key-
operator mode can transfer confidential files.
However, the bit can be left at 0 if the customer's
key-operators wish to transfer the files themselves
(this machine does not support confidential rx).
3-13
BIT SWITCHES
SP No. 1-101-003
COMMENTS
SP No. 1-101-004
COMMENTS
SP No. 1-101-005
COMMENTS
Continued...
B003/B004/B006/B007