Gestetner B003 Service Manual page 628

[A]
[B]
[I]
8. Attach the harness clamps [A] and connect the FCU harness [B] to the NCU
board. Then clamp the harness as shown.
9. Reattach the FCU cover and the controller unit.
NOTE: If the ISDN option is installed, cut away the small part from the FCU
cover for the ISDN connector. Refer to the Installation Procedure for
the ISDN Option Type 1045.
10. Remove parts [C] and [D], then install parts [E], [F] and [G]. Attach the super
G3 decal [H] to the front cover as shown.
11. Cut away the telephone connector cover [I]. Attach the FCC decal and the
serial number decal [J] to the rear cover as shown.
12. Reattach the covers.
SM
[E]
B360I106.WMF
[C]
[J]
B366I107.WMF
1-5
FAX UNIT
[G]
[F]
[D]
[H]
B360I107.WMF
B003/B004/B006/B007