PRINTER INSTALLATION
Printer Controller Installation
!
CAUTION
Unplug the main machine power cord before starting the following procedure.
1. Remove the left rear cover [A] (2 screws) and slide out the controller board [B]
(2 screws).
2. Install the printer ROM DIMM [C] on the controller board.
3. Remove the parallel interface cover [D].
4. This step is required only in the USA models.
Attach the FCC label [E] on the controller panel board aligned with the slot [F]
so the label is hidden when the left rear cover is replaced.
NOTE: If the NIB (G574), Postscript kit (G577), memory board (G578/G579), or
IEEE1394 Interface (G590) are to be installed, remove the HDD and install
them before proceeding to the next step.
5. Put back the controller board and replace the left rear cover.
B003/B004/B006/B007
[F]
[B]
[A]
B361I101.WMF
1-2
[E]
[D]
[C]
B361I107.WMF
SM