Adjusting Rear Brake Toe Peg; Adjusting Front Brake Lever; Fuel Filler Cap - EBR 1190 SX Owner's Manual

ADJUSTING REAR BRAKE TOE PEG

The rear brake toe peg can be adjusted for rider preference.
1. See Figure 13. Loosen the fastener from the toe peg.
2. Slide toe peg to the desired position.
3. Tighten the fastener to 48-72 in-lbs (5.4-8.1 Nm).
NOTE
To adjust the rear brake master cylinder pushrod, see an EBR
Dealer

ADJUSTING FRONT BRAKE LEVER

The front brake hand lever may be adjusted to the rider's
preference.
See Figure 14. Turn knob to desired position.
NOTE
It is easier to adjust the dial if you gently push the lever
outward to reduce pressure on the adjuster.
After adjusting hand lever position, rotate steering to full left
and full right positions to make certain the levers do not
contact the fairing.
Do not position fingers between hand control lever and
handlebar grip. Improper hand positioning can impair control
lever operation and cause loss of vehicle control, which could
result in death or serious injury.

FUEL FILLER CAP

Avoid spills. Slowly remove filler cap. Do not fill above bottom
of fill plate, leaving air space for fuel expansion. Secure filler
cap after refueling. Gasoline is extremely flammable and
highly explosive, which could result in death or serious injury.
Use care when refueling. Pressurized air in fuel tank can force
gasoline to escape through filler tube. Gasoline is extremely
53
^
WARNING
^
WARNING
^
WARNING