EBR 1190 SX Owner's Manual page 89

7. Install both drain plugs after thoroughly draining oil.
A. Tighten left engine oil drain plug to 18 ft-lbs
(24 Nm).
B. Tighten right engine oil drain plug to 11 ft-
lbs (15 Nm).
8. Install new oil filter cartridge, if removed.
A. Apply a light film of clean engine oil to the
rubber contact surface on the new oil filter cartridge.
B. Push new oil filter cartridge into cover until
properly seated.
C. Install oil filter cover (with filter) onto
crankcase with two screws. Tighten screws to 97 in-lbs (11
Nm).
9. Fill oil through filler hole using recommended oil from
Table 17. Always verify proper hot oil level in sight glass. Do
not overfill.
NOTE
Oil capacity with filter change is approximately 3.3
U.S. quarts (3.1 liters).
Oil capacity without filter change is approximately
3.0 U.S. quarts (2.8 liters).
10. Install (screw in) fill plug into oil fill hole. Make sure
fill plug is screwed in completely.
NOTE
For ease of installation, apply a light film of clean engine oil to
the fill plug O-ring.
Compressed air can pierce the skin and flying debris from
compressed air could cause serious eye injury. Wear safety
glasses when working with compressed air. Never use your
hand to check for air leaks or to determine air flow rates.
11. Inspect oil cooler fins for debris or damage. Blow out
any debris from fins with compressed air from the inside of
the cooler.
12. Wipe up any spilled oil on the vehicle.
89
^
WARNING