Odometer; Warning Lights And Messages - EBR 1190 SX Owner's Manual

Odometer

See figure 8. The odometer displays total mileage, mileage
for trips A and B as well mileage since the last time ignition
key was turned on (Key Trip). Key trip from previous trip is
held for reference until the vehicle starts to move at which
point it is cleared for tracking the current key on event. There
is also a reserve fuel odometer (Fuel Trip) that will appear
automatically when the fuel level drops to .7 gal (2.6 liters).
This will reset a few minutes after fuel is added to bring the
fuel level above the reserve amount. It also displays mileage
to the next recommended service.
You toggle between the various trips by pushing the center
button on the left edge of the cluster housing. See figure 10.

Warning Lights and Messages

Low Fuel
See figure 8. The Low Fuel light will turn on when the fuel
level drops to .7 gal (2.6 liters). This will also trigger the FUEL
TRIP odometer to appear and begin counting the mileage
from the beginning of the Low Fuel event.
Check Engine
See figure 8. The amber check engine lamp indicates whether
the engine management system is operating normally. When
an engine malfunction is detected, a check engine message is
displayed on the Instrument Cluster Information Line. The
check engine lamp illuminates briefly when the motorcycle's
ignition is first turned on. At this time, the engine
management system runs a series of self-diagnostics.
If the lamp remains continuously lit after the initial
diagnostics, begins flashing, or turns on at a later time, see a
EBR dealer. This indicates an event has occurred related to
the proper operation of the engine management system.
Engine Cold/Over Temp
See figure 8. The Engine Cold message will appear above the
tachometer when the engine is below operating temperature.
The ECM will reduce the engines rev limit until the engine
reaches proper temperature.
The Over Temp message will appear above the tachometer
when engine temperature exceeds the normal operating
range. Engine performance will be reduced until the
temperature drops to within the normal range. Reduce speed
and drive gently until temperature is reduced.
If Over Temp lights remains on stop the engine and check
coolant level. If coolant level is correct see Trouble shooting.
41
CAUTION