4.
Lift chain until it is tight and check chain tension by
measuring the distance from the bottom of a chain link to the
bottom of the chain rub block. Adjust distance to 30 mm +/-
2 mm as shown in figure 42.
5.
Measure axle adjuster positions on both sides of the
swingarm to ensure they are even on each side of the
swingarm. This check will ensure rear sprocket is aligned with
front sprocket. See figure 47.
6.
Tighten lock nut.
7.
Tighten axle to 100 ft-lbs (135.6 Nm)
Figure 47: Chain tension adjustors
91