EBR 1190 SX Owner's Manual page 45

7. To stop recording and end the session press and hold
the headlight flasher button for five seconds. This will stop
the session and delete the lap that is being timed. All
previous laps will be saved.
8. You can start a new session by simply pressing the
headlight flasher button to start the lap timer again.
Use the button to move around the screen to view different
sessions or laps.
Use EXIT to move up one level in the menu. You may need to
select EXIT several times to return to the main screen.
Service
See Figure 10. The service screens shows the distance to next
service and allows you to reset the counter after the service is
performed. The first service is due at 620 miles (1000 KM).
Second service is a 6,200 miles (10,000 KM). Each
subsequent service will be 6200 miles (10,000 KM) after the
previous service.
Select EXIT to return to MENU
Brightness
See Figure 10. Brightness allows you to increase or decrease
screen brightness as needed. Brightness can be configured to
change automatically based on ambient light. Use the center
(SEL) button to select brightness.
• To turn on auto brightness adjustment set AUTO
ADJUST to ON (white background/dark letters).
• The brightness level for both Day and Night can be
adjusted. Select DAY or Night using the up and down buttons.
Adjust the brightness using center button.
• You can set the brightness manually by turning the
Auto setting off. Only the DAY setting will be available for
adjustment.
NOTE
Brightness will change automatically 10 seconds after the
ambient light levels change. Light changes lasting less than
10 seconds (like passing through a small tunnel) will not
trigger the brightness change.
Select EXIT to return to MENU
Traction
See Figure 10. Traction allows you to set what level of
Traction Control you desire.
45