Respironics REMstar Pro M Series User Manual page 33

a a
lErt UdIblE
I
ndICator
Mask Leak • •
Auto Off None
Patient None
Reminder
rEm p m s
star ro ErIEs
v
IsUal
I
ndICator
Backlights:
◊ ◊ ◊
The words Mask
Leak flash on the
Active Display
screen.
The words Auto
Off flash on the
Standby screen,
indicating that a
mask disconnect
has been detected.
Backlights:
◊ ◊ ◊
Screen displays
a customized
reminder message
whenever the de-
vice transitions from
the Active state to
the Standby state.
U m
sEr anUal
d a p
EvICE CtIon ossIblE
The device continues The breathing
to operate. circuit is discon-
nected or there is
a large air leak.
The airflow shuts The mask has
off and the device been removed.
enters the Standby
state approximately
45-60 seconds after
detection.
The device continues Your home care
to operate. provider may
set a patient
reminder sched-
uled to pop up at
a particular time
to remind you
to replace your
mask, change
your filters, etc.
C p a
aUsE atIEnt CtIon
Check your breathing
circuit connections and re-
connect the tubing if it has
come loose. Press any of
the display buttons to clear
the alarm. Make sure your
mask is on properly before
you press the
restart the airflow.
If the alert continues to
occur, disable the mask
alert setting following the
instructions in Chapter 4,
and continue your therapy
overnight. Contact your
home care provider the
next morning to have your
mask checked. You may
need a mask refitting.
Put your mask back on
and press the
to turn the airflow on and
resume therapy.
Press any of the display
buttons to acknowledge
the message and clear it. If
you do not acknowledge
the reminder, it will disap-
pear after 6 minutes, and
then reappear for three
consecutive days whenever
the device transitions from
the Active state to the
Standby state. If you still do
not acknowledge the mes-
sage, the reminder period
will reset and the message
will not reappear until
the next time the Patient
Reminder setting expires.
button to
button
5-3