Table of Contents
Advertisement
PCI Express Board User's Manual
Loading the Driver
After completing the setup procedure, run BIN\DP-DRV.EXE from the DOS prompt to load the
driver. The driver will automatically detect the boards that have already been installed. If one or
more boards are detected, you will see a message similar to the following:
Smartio/Industio Family DOS driver Version 1.7
Setup driver ...
CP-168EL series (Bus= x ,Dev=y) : OK!
Device driver setup O.K.
This indicates that the CP-168EL Series driver has been installed properly. At this point, you may
execute applications that support API-232 functions, or start developing applications using the
API-232 library.
Unloading the Driver
To unload (release) the driver from memory, type DP-DRV/Q at the DOS prompt and then press
Enter.
Linux (32-bit/64-bit)
Moxa provides drivers that allow you to use the following serial board products under Linux.
• PCI Express Boards:
CP-118EL,CP-168EL,CP-104EL,CP-102E,CP-102EL,CP-132EL,CP-132EL-I,CP-114EL,CP-1
14EL-I
NOTE
The following procedure shows how to install the CP-114EL driver under Linux.
3-47
Software Installation
Advertisement
Table of Contents
Need help?
Do you have a question about the PCI Express Board and is the answer not in the manual?