Menu Setting; User Menu - Sony DSR-570WS Service Manual

4-1. Menu (LCD)
The display window (LCD) of this unit enables setting of
the system functions of this unit, and VTR menus required
for adjustments and maintenance.
The VTR menus are divided into the following three:

. USER MENU

For user operations.
. SYSTEM MENU
Used to set various system functions of this unit (This
menu is not described in the instruction manual and
therefore cannot be used by users.)
. MAINTENANCE MENU
Used for performing maintenance including adjustments.
4-1-1. User Menu
Operating the USER MENU
1. Press the MENU button in the TC panel.
(The time data on the display window changes to the
menu display.)
The display window (LCD) displays "101 xxxx" and
the USER MENU is set. (Fig. A.)
2. Press the ADVANCE button repeatedly until the Menu
No. on the display window (LCD) becomes the desired
Menu No.
Pressing the ADVANCE button (+ button) will switch
and display the menu in the following order.
101 → 201 → 204 (DSR-570WS)/206 (DSR-570WSP)
···221(DSR-570WS)/214 (DSR-570WSP) → 101···.
3. To display the desired Menu No., press the SHIFT
button. The current value setting will blink, the value
will be enabled to be changed. (Fig. B.)
4. To advance to the next digit, press the SHIFT button.
To change the set value, press the ADVANCE button
and display the desired value.
5. Press the RESET (MENU SET) button.
The set value is registered, and the Menu No. blinks
again. (Fig. C.)
6. Press the MENU button.
The display window (LCD) returns to the state before
the menu display.
n
If the MENU button is pressed during operations, the menu
will be exited without registering changes made in the
settings.
DSR-570WS/570WSP V1
Section 4

Menu Setting

Basic Operations of Buttons
Button
ADVANCE button
SHIFT button
RESET (MENU SET) button Registers the set value
MENU button
RESET
(MENU SET)
button
REC TIME SKIN DTL
TTL
ON
COMPONENT.
DUR
OFF
OFF
TTL RESET SET
PARALLEL
HYPER SET UP FRONT MIC
GAIN LOW CUT
ON
ON FILE
OFF STD OFF
Display window (LCD)
A
Initial display
B
Blinks when the set value is changeable
C
Blinking menu No. (When changed)
Function
Changes the set value
Menu No. + (Increase)
Moves between displayed digits
Menu No. _ (Decrease)
(Returns to the menu selection
mode)
Starts the adjustment
Returns to the state before the
menu mode
Interrupts the adjustment
Display window (LCD)
WARNING
PB DATE NDF EXT-LK HOLD
H MIN SEC FRM
RESET CL CONT
CLIP
TAPE DVCAM
BATT
E F
DIAG
RF SERVO HUMID SLACK
(MENU SET)
EXT VTR MENU ADVANCE SHIFT
OUTPUT
VBS
Y/C
PRESET F-RUN
MONITOR SELECT
VTR
TRIGGER CH-1
MIX
REGAIN SET
CH-2
EXT
INT ONLY
LITHIUM BATT
DATE/TIME R-RUN
EXT ONLY
ClipLink
MONITOR OUT
CONTINUE
CHARACTER
ON
OFF
MENU button
SHIFT button
ADVANCE button
LIGHT
OVER OVER
dB
ON
0
OFF
-12
-20
IP
DISPLAY
-30
COUNTER
-40
Li ∞
TC
-
F 32k U-BIT
1 8 2
F 48k
8
AUDIO LEVEL
AUTO
MAN
AUDIO SELECT
CH-1 CH-2
AUDIO IN
FRONT
VJ MIC
WRR
REAR
4-1