6-30. Replacement of Reel Motor
Reel table position: Standard cassette position
Mode: Unthreading end
Replacement Flowchart
Removal of SV-213 board
Removal of Idler gear assembly
Replacement of reel motor
Reel FG DUTY adjustment
Reel table FWD/REV rewinding torque check/adjustment
Removal
1. Remove the SV-213 board.
(Refer to Section 2-9-8.)
2. Remove the idler gear assembly.
(Refer to Section 6-26.)
3. Remove the three screws, and remove the reel
motor.
n
When the reel motor is removed, the washer
shown in the figure will also be removed with it.
Be careful not to lose the washer.
Attachment
4. Attach the new reel motor in the reverse order of
step 3.
n
After attaching, check that the gear of the reel
motor shown in the figure and gear C are
engaged.
5. Attach the parts removed in the reverse order of
steps 1 to 3.
Check/Adjustment
6. Perform the reel FG DUTY adjustment at Menu
M607. (Refer to Section 10-2-2.)
7. Perform reel table FWD/REV rewinding torque
check/adjustment. (Refer to Section 6-38.)
6-42
Screws
Reel motor
Washer
Gear (reel motor)
Gear C
DSR-570WS/570WSP V1