Table of Contents
Advertisement
6-12. Replacement of TR Band
Assembly
Reel table position: Standard cassette position
Replacement Flowchart
Removal of TG-1/TG-8 base assembly
Removal of soft brake arm (S)
Removal of sensor attachment plate assembly
Replacement of TR band assembly
Reel table FWD/REV rewinding torque adjustment
TR arm assembly position check/adjustment
FWD back tension adjustment
Tracking adjustment
Check after tracking adjustment
Check of self-recording tape playback
Removal
1. Remove the TG-1/TG-8 base assembly.
(Refer to Section 6-23.)
2. Set to the unthreading end, and remove the soft
brake arm (S). (Refer to Section 6-6.)
3. Remove the sensor attachment plate assembly.
(Refer to Section 6-15.)
4. Push part A of the TR band assembly shown in
the figure in the arrow direction, and remove it
upwards.
5. Set to the threading end, rotate part B of the TR
band assembly in arrow direction a, and remove
it from the hole of part B.
Attachment
n
Do not touch the felt part of the TR band assembly.
6. Insert part B of the new TR band assembly in the
hole, rotate it in c direction according to the
reverse steps of 4 to hold, and wind it around the
sub reel gear.
7. Set the TR band to the unthreading end without
scratching it, and insert part A of the TR band
assembly into the shaft until it locks.
8. Attach the soft brake arm (S) , sensor attachment
plate assembly and TG-1/TG-8 base assembly.
DSR-570WS/570WSP V1
Part B
a
Part B
TR band assembly
TR band assembly
c
Part A
Shaft section
TR band assembly
Part A
Part A
Sub reel gear
6-15
Hide quick links:
Advertisement
Table of Contents
