Sony DSR-570WS Service Manual page 146

6-19. Replacement of S Reel Plate
Assembly
Reel table position: Standard cassette position
Replacement Flowchart
Removal of TR band assembly (part A side)
Removal of sub reel gear (S) assembly
Removal of S reel table assembly
Removal of SV-213 board
Replacement of S reel plate assembly
S reel table assembly height check/adjustment
Reel table FWD/REV rewinding torque check/adjustment
TR arm assembly position check/adjustment
FWD back tension check/adjustment
Check after tracking adjustment
Check of self-recording tape playback
Removal
1. Remove the TR band assembly (part A side).
2. Remove the sub reel gear (S) assembly.
(Refer to Section 6-10.)
3. Remove the S reel table assembly.
(Refer to Section 6-4.)
4. Remove the SV-213 board.
(Refer to Section 2-9-8.)
5. Remove the reel plate holder shown in the figure,
and remove the S reel plate assembly.
Attachment
6. Attach the new S reel plate assembly in the
reverse order of step 5.
7. Attach the parts removed in the reverse order of
steps 1 to 4.
6-28
Check/Adjustment
8. Perform S reel table height check/adjustment. (Refer to Section
6-36.)
9. Perform the reel table assembly FWD/REV rewinding torque
check/adjustment. (Refer to Section 6-38.)
10. Perform TR arm assembly position check/adjustment. (Refer to
Section 6-40.)
11. Perform the FWD back tension check/adjustment. (Refer to
Section 6-39.)
12. Perform the check after tracking adjustment.
(Refer to Section 7-4.)
13. Perform the check of self-recording tape playback.
(Refer to Section 7-5.)
S reel plate assembly
TR band assembly
Reel plate holder
Claw
Part A side
DSR-570WS/570WSP V1