Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - RAM 1500 Owner's Manual

230 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with a switch
located in the switch bank of the instrument panel. The
system can only be enabled and disabled with a switch.
When the ParkSense
disable the system, the instrument cluster will
display the PARKSENSE OFF message for
approximately five seconds. Refer to "Elec-
tronic Vehicle Information Center (EVIC)" in "Under-
standing Your Instrument Panel" for further information.
When the shift lever is moved to REVERSE and the
system is disabled, the EVIC will display the
PARKSENSE OFF message for as long as the vehicle is
in REVERSE at or below 7 mph (11 km/h).
The ParkSense switch LED will be ON when
ParkSense is disabled or defective. The ParkSense
switch LED will be OFF when the system is enabled.
switch is pressed to

Service The ParkSense Rear Park Assist System

When the ParkSense Rear Park Assist System is malfunc-
tioning, the instrument cluster will actuate a single chime,
once per ignition cycle, and it will display the
PARKSENSE UNAVAILABLE WIPE REAR SENSORS or
the PARKSENSE UNAVAILABLE SERVICE REQUIRED
message. Refer to "Electronic Vehicle Information Center
(EVIC)" in "Understanding Your Instrument Panel" for
further information. When the shift lever is moved to
REVERSE and the system has detected a faulted condition,
the EVIC will display the PARKSENSE UNAVAILABLE
WIPE REAR SENSORS or the PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED message for as long as the
vehicle is in REVERSE. Under this condition, ParkSense
will not operate.