RAM 1500 Owner's Manual page 303

Operation of the Brake Warning Light can be checked by
turning the ignition switch from the OFF position to the
ON/RUN position. The light should illuminate for ap-
proximately two seconds. The light should then turn off
unless the parking brake is applied or a brake fault is
detected. If the light does not illuminate, have the light
inspected by an authorized dealer.
The light also will turn on when the parking brake is
applied with the ignition switch in the ON/RUN position.
NOTE: This light shows only that the parking brake is
applied. It does not show the degree of brake application.
7. High Beam Indicator
This indicator shows that headlights are on high
beam. Push the multifunction lever forward to
switch the headlights to high beam, and pull toward
yourself (normal position) to return to low beam.
Shows level of fuel in tank when ignition switch is in the
ON/RUN position.
UNDERSTANDING YOUR INSTRUMENT PANEL 301
8. Seat Belt Reminder Light
When the ignition switch is first turned to ON/
RUN, this light will turn on for four to eight sec-
onds as a bulb check. During the bulb check, if the
driver's seat belt is unbuckled, a chime will sound. After
the bulb check or when driving, if the driver's seat belt
remains unbuckled, the seat belt reminder light will flash
or remain on continuously. Refer to "Occupant Re-
straints" in "Things To Know Before Starting Your Ve-
hicle" for further information.
9. Air Bag Warning Light
This light will turn on for four to eight seconds
as a bulb check when the ignition switch is first
turned to ON/RUN. If the light is either not on
during starting, stays on, or turns on while
driving, have the system inspected at an authorized
dealer as soon as possible. Refer to "Occupant Restraints"
in "Things To Know Before Starting Your Vehicle" for
further information.
4