RAM 1500 Owner's Manual page 450

448 STARTING AND OPERATING
NOTE: Aero Mode may be disabled through vehicle
settings in the Electronic Vehicle Information Center
(EVIC) or in the Uconnect™ Access 8.4 Radio (If
Equipped). Refer to "Electronic Vehicle Information Cen-
ter (EVIC)" in "Understanding Your Instrument Panel"
or "Uconnect™ Access Settings" in "Understanding Your
Instrument Panel" for further information.
• Entry/Exit Mode (Lowers the vehicle approximately 2 in
(51 mm) – This position lowers the vehicle for easier
passenger entry and exit as well as lowering the rear of
the vehicle for easier loading and unloading of cargo.
To enter Entry/Exit Mode, press the "Down" button
once while the vehicle speed is below 33 mph
(53 km/h). Once the vehicle speed goes below 15 mph
(24 km/h) the vehicle height will begin to lower. If the
vehicle speed remains between 15 mph (24 km/h) and
25 mph (40 km/h) for greater than 60 seconds, or the
vehicle speed exceeds 25 mph (40 km/h) the Entry/
Exit change will be cancelled. To return to Normal
Height Mode, press the "Up" button once while in
Entry/Exit or drive the vehicle over 15 mph
(24 km/h).
NOTE: Entry/Exit mode may be achieved using your
key fob for easier entry/loading. Refer to "A Word About
Your Keys" in "Things To Know Before Starting Your
Vehicle" for further information.
The system requires that the ignition be in ON/RUN
position or the engine running for all user requested
changes. When lowering the vehicle all of the doors,
must be closed. If a door is opened at any time while the
vehicle is lowering the change will not be completed
until the open door(s) is closed.
This system uses a lifting and lowering pattern which
keeps the headlights from incorrectly shining into on-
coming traffic. When raising the vehicle, the rear of the
vehicle will move up first and then the front. When
lowering the vehicle, the front will move down first and
then the rear.