Rear Axle And 4X4 Front Driving Axle Fluid Level - RAM 1500 Owner's Manual

WARNING! (Continued)
• Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in a collision.

Rear Axle And 4x4 Front Driving Axle Fluid Level

For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons
the exterior surfaces of the axle assembly should be
inspected. If gear oil leakage is suspected inspect the
fluid level. Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for further informa-
tion. This inspection should be made with the vehicle in
a level position.
For 1500 Model axles, the fluid level should be even with the
bottom of the fill hole (within 1/4 in (6.4 mm) of edge of
hole) for the FDU215 HD front axle and C235FE rear axle.
MAINTAINING YOUR VEHICLE 679
For all 2500/3500 Model axles, the fluid level should be
1/4 in ± 1/4 in (6.4 mm ± 6.4 mm) below the fill hole on
the 9.25 in front and 3/4 in ± 1/4 in (19 mm ± 6.4 mm) on
10.5 in rear axles. The 11.5 in rear axle level should be
1/4 in ± 1/4 in (6.4 mm ± 6.4 mm) below the fill hole.
Drain And Refill
Refer to the "Maintenance Schedule" for the proper
maintenance intervals.
Lubricant Selection
Refer to "Fluids, Lubricants, and Genuine Parts" in
"Maintaining Your Vehicle" for further information.
NOTE: The presence of water in the gear lubricant will
result in corrosion and possible failure of differential
components. Operation of the vehicle in water, as may be
encountered in some off-highway types of service, will
require draining and refilling the axle to avoid damage.
7