Table of Contents
Advertisement
CAUTION
The projector inside the 2000i has been designed for use under normal operating
conditions only. Normal operating conditions are defined as product use that does
not exceed 8 hours per day and 260 days per year. Exceeding these operating
conditions could cause projector damage. Damage caused by such extended use
will not be covered by the product warranty.
To maintain normal operating conditions, make sure the projector is in standby
mode outside of normal, daily (8 hour) operation. In standby mode, the lamp is
powered down, while the projector remains on. Be sure to press the Lamp Off
button in the Control Panel at the end of the day, and your projector will remain in
standby mode until you press the Lamp On button the next day.
NOTE: You can also configure the computer's power management settings so that
it stops sending out a video signal after a period of idle time (page 27). This also
turns off the projector.
Other Precautions
For operating safety and to avoid damage to the cabinet and its parts, please read the following
information carefully.
•
Move the unit with care. Quick stops, excessive force and uneven surfaces can overturn the
unit.
•
When you transport the 2000i, only ship it in an upright position and never lay the interactive
whiteboard face down. In addition, ensure that the projector is secure, or remove and
repackage it in the original projector's packaging.
•
If you transport the 2000i over a distance, we strongly urge you to completely repackage it
using the original packaging. This packaging was designed with optimal shock and vibration
protection. If the original packaging is no longer available, pack all components with as much
padding as reasonably possible to ensure that they are not exposed to excessive vibration or
shock.
•
Clean the interactive whiteboard surface regularly so dust doesn't build up on the surface and
adversely affect the operation of the 2000i.
•
Do not touch the rear surface of the screen or apply isopropyl alcohol, water or acetone. If any
of these fluids come into contact with this surface, the diffusion coating will be damaged,
resulting in a permanent deterioration in display quality.
•
If you inadvertently smudge the rear surface of the screen, dab it carefully with a soft cloth and
alcohol-free glass cleaner. Do not spray glass cleaner directly on the back of the screen; spray
it lightly on the cloth, and then gently dab the rear surface until the marks are removed.
•
The 2000i uses digital cameras located inside the screen frame. Do not allow excess glass
cleaner to flow into the crack between the frame and the writing surface, because the cleaner
could damage these cameras.
iv
Lamp On Button
(Press to Resume Operation)
Important Information
Lamp Off Button
(Press for Standby Mode)
Advertisement
Table of Contents
