Startup Scenarios - Smart Technologies 2000i-DVX Installation Manual

Startup Scenarios

If more than one person uses the 2000i, you may occasionally find that another user has turned
the unit off completely rather than placed it in standby mode. The following table describes what
you may need to do to restore the 2000i to a fully operational state.
What You See
• Screen is black
• On LED is blinking
intermittently (short
flashes between long
pauses)
• Blue "No Input" screen
• On LED is steadily
illuminated
• Screen is black
• On LED is blinking
slowly
• Screen is black
• Off LED is blinking
rapidly
• Logon Screen
• Lamp On LED
continues to blink
intermittently, even
though it's been
pressed to start the
system
• The Lamp Off and On
LEDs are both
flashing constantly
34
What You Should Do
The projector is in standby mode (with the lamp off).
Press the Lamp On button on the control panel. The Lamp On LED
indicator blinks quickly as the lamp warms up, and, after
approximately 60 seconds, either a blue "No Input" screen appears
(see below) or the screen is restored to its last active state.
The projector lamp is on, but the computer is either off or in standby
mode, or you've selected an inactive display source.
Press a key on the connected keyboard to activate the computer. The
logon screen appears.
OR
Press a source button on the control panel to change to an active
source. If the blue "No Input" screen remains, turn the computer on (or
press the computer's reset button) and log on as usual (using the
connected keyboard).
No action is necessary. The projector lamp is turning on, and the logon
screen will appear after approximately 60 seconds.
The projector lamp is in reversible standby mode. If you don't press a
button to restore the image, after three minutes the On LED indicator
will blink slowly for 60 seconds as the lamp turns off and cools down.
At this point, follow the first set of instructions in this table to restore
the 2000i to an operational state.
The projector lamp is still on, so you can log on as usual (using the
connected keyboard).
Projector problems are preventing a normal projector lamp warm-up.
Examine the projector status LED indicator, and then consult the
troubleshooting section of the NEC VT470/570/670 User's Manual.
The system can't detect a projector. Check the NEC VT470/570/670
User's Manual to make sure the projector is connected properly.
Basic Operations