Smart Technologies 2000i-DVX Installation Manual page 57

5. Detach the power cable labeled Projector AC from the AC IN socket, the 8 pin Mini DIN cable
labeled PC Control from the PC Control port and the HD DB15 video cable labeled RGB 1 IN
from the Computer IN port of the projector's connection panel.
NOTE: The
projector is
shown upside
down, as
installed.
The diagram above shows the connectors as installed at the factory. When you reconnect the
cables, you can return each cable to its correct port as indicated by its label. However, your
configuration will be different if you have installed other equipment.
Use the following table on the next page to keep track of each cable's port.
• The first column lists the port's type and label as it appears on the projector and the port
type
• The second column shows the label of the cable that was originally connected to that port
at the factory
• The third column is for you to note which cable you have connected to each port. To do
this, write the name of each cable on a piece of masking tape and attach each piece of
tape to the corresponding cable. Then, using column three, note to which port each cable
connects.
46
Projector AC
Maintenance and Troubleshooting
PC Control
RGB 1 IN