Smart Technologies 2000i-DVX Installation Manual page 56

To replace the projector lamp
1. If you need better access to the rear of the cabinet, retract the anti-tip feet and unlock the
wheels by raising the caster tab locks on each wheel. Then roll the unit away from the wall,
press the caster tab locks down to lock the wheels, and extend the anti-tip feet.
2. Using the height-adjustment handle, raise the unit to allow easier access to the projector.
3. Shut down the computer. Press and hold the Lamp Off button on the control panel for
approximately three seconds. The screen will turn black. Release the button and the projector
lamp turns off in 60 seconds.
After you turn off the projector, allow at least one minute to elapse before you
WARNING
unplug it. Do not touch or replace the projector lamp (which will be very hot) for
at least an hour.
Après avoir éteint le projecteur, attendez au moins une minute avant de le
débrancher. Attendez au moins une heure avant de toucher ou de remplacer la
lampe du projecteur (qui sera très chaude).
Stecken Sie den Projektor für mindestens eine Minute nach dem Abschalten
nicht aus. Berühren oder ersetzen Sie die Projektorlampe (die sehr heiß sein
wird) nicht vor Ablauf einer Stunde.
4. Unplug the 2000i from the power outlet.
Maintenance and Troubleshooting
Lamp Off Button
45