Table of Contents
Advertisement
Basic Operations
This section shows you how to:
•
Start up the 2000i (this page)
•
Put the 2000i into standby (page 35)
•
Adjust the height of the interactive whiteboard (page 36)
•
Adjust the volume (page 37)
•
Change the projector display source (page 38)
•
Use the interactive whiteboard (page 39)
Starting Up the 2000i
You should keep the projector on at all times. However, to conserve the projector lamp, press the
Lamp Off button on the control panel at the end of your session (or at the end of the day). For
ease of operation, you should also keep the computer on all the time. By doing this, you can start
up the 2000i by restoring power to the projector lamp (by pressing the Lamp On button on the
control panel) and then entering your user name and password at the logon screen.
NOTE: To preserve the computer's hard drive(s) and the projector lamp, you may want to put the
computer hard drive and the monitor (interactive screen) into standby mode. Refer to page 27 for
instructions.
To start up the 2000i
1. If the screen is black, press the Lamp On button on the control panel to turn on the projector
lamp. The Lamp On LED indicator should blink quickly for approximately 60 seconds and then
remain illuminated after the lamp has turned on.
Lamp On
Lamp On LED
2. If you see a logon screen, use the connected keyboard to enter your logon ID and password,
and then press the OK button.
OR
If the screen turns from black to blue—and no logon screen appears—you may need to turn
on the computer or restore it from a standby setting. Turn the computer on or press the reset
button (if required).
See the next page for possible startup scenarios.
Basic Operations
33
Advertisement
Table of Contents
