Table of Contents
Advertisement
Setting Up Your 2000i
This section of the manual describes how to:
•
position the 2000i (this page)
•
install and connect the host computer (page 10)
•
install the videoconferencing/laptop shelf (page 13)
•
connect a guest laptop (page 14)
•
connect a VCR or DVD player (page 14)
•
connect an external sound system (page 19)
•
connect an external projector or monitor (page 19)
No matter what peripherals you install, you must finalize your installation before you can use the
2000i. Read the next section of this guide (page 21) for information on finalizing your installation.
Positioning the 2000i
1. Remove the unit from its shipping carton. (To do this, follow the Unpacking Instructions.)
2. Unpack the remaining contents of the shipping carton and wheel the unit to a location that's
within reach of a power source.
NOTE: Leave enough space around the unit to comfortably perform the following assembly
and connection procedures.
3. Lock the casters by pressing down on the caster-lock tab, as shown in the figure below.
NOTE: You can unlock the casters by pressing up on this tab.
4. Extend all four of the anti-tip feet. You'll see two holes on the outer side of each leg. To extend
the feet, depress the locking ball in the inner hole, and then pull the leg out until the locking
ball engages in the outer hole.
A Locked and Unlocked Caster
Locking Ball in the
Inner Hole
Extending an Anti-Tip Foot
Setting Up Your 2000i
Locking Ball in the
Outer Hole
9
Advertisement
Table of Contents
