Table of Contents
Advertisement
Perform this procedure at the end of a meeting or presentation and at the end of the day. If you
prefer, you can also shut down the computer. However, for greater ease of use, we
recommend simply logging off rather than turning off the computer.
To power down the projector (if unused for an extended period)
1. Log off (as described above) and turn off the computer.
2. Press the Lamp Off button on the control panel.
The Lamp Off LED indicator blinks rapidly for three minutes (reversible standby), and then
slowly for approximately 60 seconds while the lamp cools down. When the lamp is off, the
Lamp On LED indicator blinks very slowly.
OR
Press and hold the Lamp Off button for three seconds. The lamp immediately turns off and
enters a 60-second cool-down period.
3. When the cooling fan stops, flip the power switch on the back of the projector.
4. Disconnect the 2000i power cable from the wall power outlet.
Adjusting the Height of the Interactive Whiteboard
It's easy to raise or lower the interactive whiteboard to accommodate users of different heights—
even while the system is in operation. The 2000i has a height adjustment range of 14" (35.6 cm)
so that anyone can comfortably touch or write on the screen.
To gauge the height of the unit as you turn the height adjustment handle, or to adjust it to a
particular height, watch the height finder located on the side of the unit, just above the handle.
NOTE: If the computer on the storage tray is unusually tall, be careful not to lower the interactive
whiteboard on top of it.
36
Basic Operations
Height Finder
Advertisement
Table of Contents
