Sharp MX-3500N Service Manual page 96

(from Previous page)
printer color balance, density adjustment. (SIM 67-25)
No
printer color balance
Auto color balance adjustment
service target is set.
Enter the SIM 67-27 mode.
Press the SETUP key.
Set the color patch image (adjustment
pattern) printed in the printer color
balance/density adjustment on the original
table, and press the EXECUTE key.
Press the REPEAT key.
Press the EXECUTE key.
Press the OK key.
Cancel SIM 67-27.
The printer color
balance and density
adjustment completed.
(from Previous page)
Can the
printer color balance and
density be adjusted to satisfactory
levels with the fine
adjustment?
Yes
4
Perform the manual adjustment of ADJ 21C
Yes
Is PCL mode
supported?
No
Use SIM 67-25 to print the color balance
check sheet, and check the patch color
balance of process black.
Use SIM 67-25 to print the color balance
check sheet, and check the patch color
balance of process black./Check the
printer color balance and density.
(Check the test pattern of SIM 64-5)
Yes
Are the printer
No
color balance and density
at satisfactory
levels?
Were the
and density
customized?
Yes
No
color balance density
adjustment performed
MX3500N ADJUSTMENTS 6 – 51
No
No
Is PCL mode
supported?
Yes
Use SIM 67-25 to print
the color balance
check sheet, and
check the patch color
balance of process
black./Check the
printer color balance
and density.
(Check the test pattern
of SIM 64-5)
Use SIM 67-25 to print
the color balance
check sheet, and
check the patch color
balance of process
black.
Are
the color
balance and density at
the satisfactory
levels?
Yes
Were
the three kinds of
color balance/density
adjustment targets
changed?
(SIM 67-26)
No
No
Yes
Is the printer
with SIM67-25?
*1: When adjusting to a customized color balance, select the SERVICE mode.
: Standard adjustment flow
Perform ADJ 21B printer color balance/
3
density auto adjustment. (SIM 67-24)
Enter the SIM 67-24 mode and select
A3 (11 x 17) paper. (Auto selection)
Press the EXECUTE key.
(The adjustment pattern 1 is printed.)
Set the adjustment pattern 1 on the
original table, select the FACTORY
mode, and press the EXECUTE key.
(Auto adjustment step 1) *1
Press the OK key. (The initial
setup of half tone image correction
is automatically performed.)
Cancel SIM 67-24.
No
Were
all the three kinds
of color balance/density
adjustment targets
changed?
(SIM 67-26)
No
Change the color balance/
density adjustment factory
targets. (SIM 67-26)
Yes
Make the factory printer balance target
(when adjusting the printer color
balance/density with SIM 67-24) same
as the service color balance target and
the color balance target when adjusting
the density. (SIM67-28)
Is PCL mode
supported?
Yes
Execute the half tone image correction.
(Forcible execution) (SIM 44-26)
Check the printer color balance/density.
(Check the test pattern of SIM 64-5)
Are the
printer color
balance and the density
in the specified
level ?
Yes
4
Yes
3
No