Rear Panel - Korg Pa3X 76-keys User Manual

Rear Panel

Music stand and speakers
Music stand / Amplification bar support
This guide can be used to connect either the supplied music
stand or the optional PaAS amplification system.
A music stand comes standard with your Pa3X. For instructions
on how to install it, see on page 27.
The (optional) PaAS – Amplification System can be installed,
adding a three-way amplification system, a pair of integrated
speakers and a bass-reflex box. For instructions on how to install
it, see "Installing the Pa3X Amplification System (PaAS)" on
page 248.
Speakers connector and pin hole
The connector and pin hole are used when the (optional) PaAS –
Amplification System is installed. See "Installing the Pa3X
Amplification System (PaAS)" on page 248.
(a)
Note: Since the Pa3X must recognize the new circuit, the inte-
grated speakers will start operating only a few seconds after the
speaker box has been installed.
Pa3X 76-keys
Pa3X 61-keys
The output volume of the integrated loudspeakers can be con-
trolled via the MASTER VOLUME slider.
Note: Speakers are automatically deactivated when connecting the
headphones. You can manually deactivate them by using the
"Speakers On/Off " parameter of the "Audio Setup" section of the
Global mode (see "Speakers On/Off " on page 216).
Audio Input Section
Use these connectors to connect a microphone, another key-
board/synthesizer, or a CD player.
MIC
Only active when the "Input Routing" parameter is set to "Mic In
to Voice Processor" (Global > Audio Setup > Audio In page, see
page 215).
Connect your microphones, guitars, or any other musical instru-
ment, to the AUDIO INPUTs on the back of the instrument. A
microphone connected to the MIC input is also sent to the Voice
Processor for sophisticate processing.
This is a combo connector, featuring an XLR and a 1/4" jack on
(b)
the same connector. Use the balanced XLR jack to connect a
condenser microphone, or the 1/4" jack to connect a dynamic
microphone.
The internal +48V Phantom Power on the MIC input also allows
to connect any condenser microphone. After having connected a
condenser microphone, use the "+48V Phantom Power" soft
switch to turn the +48V phantom power on (in the Global mode,
Overview
19
Rear Panel