Showing, Moving, And Turning Off The Pip; Controlling What You Hear; Adjusting Volume - Polycom V500 System Getting Started Manual

Showing, Moving, and Turning Off the PIP

Controlling What You Hear

Adjusting Volume

© Polycom, Inc.
During a call, the Picture-in-Picture (PIP) displays what your camera is sending
to the far site. (This lets you adjust the camera if you need to.) If the far site
shows any type of content, the content appears in the main part of the screen,
and the PIP changes to show the people at the far site.
To show, move, or turn off the PIP during a call:
Press PIP on the remote control to turn the PIP on.
While the PIP has a yellow border, press
different corners of the screen.
After a brief pause, the PIP border turns blue. Then, press
the PIP off.
To swap the views shown in the PIP and the main screen:
1. If the PIP is not showing, press
display the PIP on the screen.
2. Press Near twice and select the
During calls using the Dual Monitor Emulation feature (split-screen viewing),
you can use the PIP button to scroll through the following screen layouts (if
you are not viewing content):
1. Near and far site, same size, side by side
2. Far site big, near site small
3. Near site big, far site small
4. Near site, full screen
5. Far site, full screen
Use the remote control to raise or lower the volume of the sound you hear.
Changing the volume affects only the sound you hear at your site.
To adjust the volume:
>>
Press Volume on the remote control.
C
ONTROLLING
PIP repeatedly to move it to
PIP on the remote control to
Swap PIP icon.
W Y H
HAT OU EAR
PIP to turn
9