Table of Contents
Advertisement
46
Automatic Satellite
Recording
This function allows you to automatically record a
satellite programme using the timer equipped for the
satellite receiver connected to the L-2 IN connector on
the rear.
When the signals come into the unit from the satellite
receiver, the unit automatically turns on and starts
recording.
• When the satellite receiver is turned off by its timer,
this unit also turns off automatically (into standby
mode).
3
ATTENTIONS
• Be sure not to turn on the satellite receiver before
Automatic Satellite Recording start recording;
otherwise, this unit will start recording when you
turn on the satellite receiver manually.
• If you have connected any external component
other than a satellite receiver to the L-2 IN
connector, activating Automatic Satellite Recording
will start recording automatically when the external
component is turned on.
• While Automatic Satellite Recording is activated,
recording timer is temporarily deactivated. When
Automatic Satellite Recording is over, recording
timer is activated again.
TIMER RECORDING (cont.)
Before performing the following steps:
• Set the timer on the satellite receiver correctly.
• When using the remote control, slide the DVD/TV/
HDD selector to the right (HDD), then press ENTER.
1
Set the timer equipped for the satellite
receiver correctly.
• For timer setting of the satellite receiver, refer to the
instruction manual supplied for the satellite receiver.
2
Select the recording speed.
Press REMAIN/REC MODE on the remote control
repeatedly until the recording speed you want is selected
(see page 24).
3
Activate Automatic Satellite Recording.
Press and hold SAT
(timer) for about 2 seconds so that
the button itself illuminates (in orange).
• The unit automatically enters standby mode.
To deactivate Automatic Satellite Recording, press SAT
(timer).
To cancel Automatic Satellite Recording while recording
is being made, press
NOTES
• The lamp next to the ¶ (record) button lights and the
(timer)
button starts flashing while Automatic Satellite
Recording is in progress.
• Some satellite receivers emit signals even if the power is off.
Automatic Satellite Recording is not possible with these
satellite receivers. (In this case, The lamp to the ¶ (record)
SAT
button lights and the
when you activate Automatic Satellite Recording.)
• When using Automatic Satellite Recording, you cannot set a
different recording speed for each programme. To do it, use
Automatic Satellite Recording separately for each programme.
• With some satellite receivers connected, this unit may not be
able to be synchronized to start and stop recording as exactly
as set by the timer equipped with these satellite receivers.
• If you activate Automatic Satellite Recording while the satellite
receiver is turned on, this unit does not start Automatic
Satellite Recording.
• You can also record a programme from your cable system in
the same way if the system has a timer.
• Just Clock (see page 69) does not work while Automatic
Satellite Recording is being activated.
(STANDBY/ON).
(timer)
button starts flashing
SAT
Advertisement
Table of Contents
