JVC LET0239-001A Instructions Manual page 12

12
Connecting a TV with the audio/video jacks
TV or monitor
S-video input
Audio/video input
Audio/video cable
(supplied)
S-Video cable
(not supplied)
DVD/HDD DVD
VIDEO AUDIO VIDEO SIGNAL
DVD DIGITAL OUT OUT OUT SELECTOR
VIDEO LEFT
PCM / STREAM
COAXIAL OPTICAL COMP.
Y / C
/ RGB
S-VIDEO
RIGHT
XV-DDV1SL
After the connection is complete, perform "Auto
Setup" on page 13.
TV aerial cable
(not supplied)
Aerial conncetor
RF cable
(supplied)
L-1
IN/OUT
SAT CONTROL
L-2
IN
AV
COMPU LINK
1
Disconnect the TV aerial cable from the TV.
2
Connect the TV aerial cable to the ANTENNA
IN conncetor on the rear.
3
Connect the RF cable (supplied) between the
ANTENNA OUT conncetor on the rear and the
TV's aerial conncetor.
4
Connect one of the VIDEO OUT jacks (either
VIDEO or S-VIDEO) on the rear to the TV's
VIDEO or S-VIDEO input jack.
NOTE
You can obtain high-quality pictures by using S-VIDEO
connection.
5
Connect the AUDIO OUT (LEFT/RIGHT) jacks
to the TV's AUDIO IN jacks.
6
Plug in the unit.
The illumination lamp on the unit flashes about 30
seconds.
• During this period, the unit starts up the HDD and
accepts no operations.
To connect this unit to a satellite receiver, and a
stereo system (see pages 86 and 87).
IN
Precautions on connecting the power cord
OUT
ANTENNA
Warning
• Disconnect the power cord:
- if you are not going to use the unit for a long time.
- before cleaning the unit.
- before moving the unit.
• Do not:
- connect or disconnect the power cord with wet hands.
- pull the power cord when disconnecting it, as this
may damage the cord and cause fire, electric shock, or
other accidents.
Caution
• Do not alter, twist or pull the power cord, or put
anything heavy on it, which may cause fire, electric
shock, or other accidents.
• If the cord is damaged, consult a dealer and have the
power cord replaced with a new one.
INSTALLING THE UNIT (cont.)