JVC LET0239-001A Instructions Manual page 18

18
Setting satellite receiver's brand and
programme positions
After installation, set the satellite receiver's brand
correctly; otherwise, the satellite controller cannot work
correctly.
T
1
2
Press SET UP.
• The HDD SET UP screen appears.
NOTE
If the built-in clock has not been set, the INTIAL SET UP screen
appears. If this happens, set the clock first (see page 69).
3
1
5,6
2
4
2
Press
3–7
"SAT CONTROL SET," then
press ENTER or
5
Press the appropriate number
buttons to enter the brand
code from the list on page
19, then press ENTER.
• If the brand code you
NOTE
If the unit is playing or recording, you cannot set the brand
code.
6
Press the appropriate number
buttons to enter one of the
programme positions (1 to
999) for the satellite receiver,
then press ENTER.
• The unit makes a trial to
INITIAL SETTINGS (cont.)
Turn on the satellite receiver.
Show the Main Setup screen on the unit.
Select the Initial Set screen.
or 2 to move
3
Press
∞
press .
or 2 to move
3
Press
ENTER.
Select the Sat Control Set screen.
or ∞ to move
5
to
3
.
Enter the satellite receiver's brand.
entered is invalid, the code
field will be reset. Enter the
correct brand code again.
Select a programme position number for the
satellite receiver for a test.
change to the selected
programme position
number on the satellite
receiver.
to "INITIAL SET UP," then
to "INITIAL SET", then press
[ENTER]
[SET UP]
[ENTER]
[SET UP]
[ENTER]
[SET UP]