Setting the satellite
controller
Remote sensor
Satellite receiver
21-pin SCART cable
DVD/HDD
DVD
VIDEO
AUDIO
VIDEO SIGNAL
OUT
OUT
SELECTOR
DVD DIGITAL OUT
VIDEO
LEFT
PCM / STREAM
COAXIAL
OPTICAL
COMP.
Y / C
/ RGB
S-VIDEO
RIGHT
XV-DDV1SL
Satellite receiver
Transmitter
Satellite controller
(Supplied)
Suggested location of
the satellite controller
(not supplied)
L-1
IN/OUT
IN
SAT CONTROL
L-2
IN
OUT
AV
ANTENNA
COMPU LINK
The following procedure is required if you receive
satellite programmes through a satellite receiver.
Approximately 20 seconds before a timer recording
starts, the unit sets its input mode to "L-2" (or "SAT") and
automatically changes the programme position numbers
on the satellite receiver by sending a signal to your
satellite receiver.
Installing satellite controller
1
Situate the satellite controller.
Place the satellite controller so that the path between its
transmitter and the remote sensor on the satellite receiver
is unobstructed.
2
Attach the satellite controller.
Fix securely using the adhesive strip attached on the back
of the satellite controller.
3
Make connections.
Be sure to connect the L-2 IN connector on the rear to the
21-pin SCART connector on the satellite receiver.
NOTE
When connecting your satellite receiver, refer to its instruction
manual.
4
Connect the satellite controller to the unit.
Connect the satellite controller to the SAT CONTROL
connector on the rear.
17