Attaching Cables And Antennas; Using Setup Wizard - Multitech rCell 500 Series User Manual

Attaching Cables and Antennas

1. Attach 4G antennas to the device's front panel by screwing them into the designated connectors.
2. Attach WiFi antennas to the device's side panel by screwing them into the designated connectors.
3. Attach cables to their corresponding ports on the device's front panel.
Note: During configuration use ports E2 to E4 only. DO NOT attach Ethernet cable to E1/WAN port.
4. Attach red wire on the power cable to PWR1 and the black wire to the GND for PWR1 on the power port
on the device's side panel.

Using Setup Wizard

Configure this device using the web UI. To access the web UI, enter the IP Address into your browser. The default
IP Address is 192.168.2.1. If this has been changed, type in the new IP Address. On the login page, type the
administrator password and click Login.
Note: The default administrator username and password is admin.
®
MultiConnect rCell 500 Series Router User Guide
INSTALLING AND USING THE ROUTER
15