Table of Contents
Advertisement
Wireless Client List
The Wireless Client List page you can see the connected wireless clients. You can choose to see all connected
clients or only clients on a specific AP.
Advanced Configuration
Advanced wireless setup is used to optimize the wireless performance under the specific installation environment.
■
Beacon Interval: Beacons are broadcast packets that are sent by a wireless AP/router.
■
DTIM Interval: When the wireless router has buffered a broadcast or multicast messages for clients, it sends
a DTIM with a DTIM interval value.
■
RTS Threshold: Adjusting the RTS threshold value can improve wireless performance if there is an excessive
number of wireless packet collisions.
■
Fragmentation: Wireless frames are divided into smaller units to improve performance in the presence of
RF interference.
■
WMM: WMM helps control latency and jitter when transmitting multimedia content over a wireless
connection.
■
TX Rate: Choose Best for auto-adjustment based on WiFi signal quality in the current environment.
■
Transmit Power: You can lower the power ratio to prevent transmissions from reaching beyond your
corporate/home office or designated wireless area.
IPv6 Setup
IPv6 is a version of the Internet Protocol (IP) intended to succeed IPv4. IPv6 implements additional features not
present in IPv4. It simplified aspects of address assignment, network renumbering, and router announcements.
This device supports Static IPv6, DHCPv6, PPPoE, 6 to 4, and 6 in 4 connection types. Confirm with your ISP what
type of IPv6 is supported before you proceed with IPv6 setup.
Note:
IPv6 isn't supported when WAN type is 3G/4G.
Static IPv6
When setting up Static IPv6, do the following:
■
WAN IPv6 address settings:
■
IPv6 address: Enter the IPv6 address. IPv6 addresses are 128 bits, the address space is larger then IPv4.
Note:
An example of an IPv6 address is "2001:0db8:85a3:0000:000:8a2e:0370:7334"
■
Subnet Prefix Length: Enter the prefix length of the Subnet Mask.
■
Default Gateway: Enter the default gateway.
■
Primary/Secondary DNS: Add IPv6 primary and secondary DNS addresses.
■
LAN IPv6 address settings: Enter the LAN IPv6 address and ignore the LAN IPv6 Link-Local address.
■
Address auto-configuration settings:
■
Auto-configuration: Disable or Enable auto-configuration.
■
Auto-configuration type: Select stateless or stateful (Dynamic IPv6).
■
Router Advertisement Lifetime: Each router periodically multicasts a Router Advertisement from each of
its interfaces, announcing the IP address(es) of that interface. Use this option to set the time period that
the router broadcasts its router advertisements.
®
MultiConnect
rCell 500 Series Router User Guide
BASIC NETWORK
25
Advertisement
Table of Contents
