Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Motorola Symbol MT2070 User Manual

5 - 2 Symbol MT2070/MT2090 User Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 5-1 lists defaults for user preferences parameters. Scan the appropriate bar codes in this guide. These new
values replace the standard default values in memory. To recall the default parameter values, scan the
Parameter on page
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 5-1
Parameter
User Preferences
Set Default Parameter
Host Mode
Decode Pager Motor Enable
Parameter Bar Code Scanning
Beep After Good Decode
Beeper Tone
Beeper Volume
Hand-Held Trigger Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Hand-Held Decode Aiming Pattern
Decoding Illumination
5-4.
Appendix A, Standard Default Parameters
F1h A4h
F1h 65h
ECh
38h
91h
8Ch
8Ah
F0h 92h
88h
89h
F0h 32h
F0h 2Ah
Beeper Tone on page
for all user preferences, hosts, symbologies, and
Parameter
Number
Set Defaults
Cable Priority
Disable
Enable
Enable
Medium
High
Standard (Level)
Disabled Always
9.9 Sec
0.5 Sec
Enable
Enable
5-8. The device issues a fast
Set Default
Default Page Number
5-4
5-5
5-6
5-7
5-7
5-8
5-9
5-10
5-11
5-10
5-12
5-12
5-13