Connecting To An Ibm 468X/469X Host - Motorola Symbol MT2070 User Manual

10 - 2 Symbol MT2070/MT2090 User Guide

Connecting to an IBM 468X/469X Host

Connect the device directly to the host interface.
Host Port Connector
IBM Direct Connection
Figure 10-1
NOTE Connect a power supply to the cradle (not shown) for fast charging.
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the device are the
same.
Attach the modular connector of the IBM 46XX interface cable to the cable interface port on the device.
1.
Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).
2.
Select the port address by scanning the appropriate bar code from
3.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
4.
NOTE The only required configuration is the port address. The IBM system typically controls other device
parameters.
Interface Cable
Figure 10-1
Port Address on page 10-4.
are examples